How Much Snow Can a Roof Hold? A Chicago-Area Guide
A foot of fluffy snow and a foot of wet, packed snow are not the same load. Here is how to think about snow weight on a Chicago-area roof, and when to get it off.
The short answer
A sound, code-built roof in the Chicago area is designed to carry far more snow than most winters put on it. Building codes set a design snow load for each region from long-term weather records, and the ground snow load commonly used for the Chicago area is around 25 pounds per square foot, adjusted for the roof's shape, exposure and slope. Your municipality's adopted code edition sets the exact number. The problem is rarely one normal snowfall. It is heavy, wet snow on top of old packed snow and ice, drifts piled against a higher wall, or an older or damaged roof that no longer has its original strength.
Why the kind of snow matters more than the depth
Snow weight varies enormously with how much water is in it. FEMA's snow load safety guidance gives rough rules of thumb: about 10 to 12 inches of fresh, dry snow weighs around 5 pounds per square foot; old, packed snow reaches that weight at 3 to 5 inches; and an inch of ice weighs about the same as a foot of fresh snow. So two feet of fresh powder may be fine, while a foot of wet March snow sitting on a January ice layer can be several times heavier. Depth alone tells you very little.
Flat roofs and drifts are where the risk is
Pitched residential roofs shed snow as it warms and slides. Flat and low-slope roofs hold all of it, and wind piles it into drifts against parapets, rooftop units, and the walls of taller sections. A drift against a higher wall can put several times the average load on a narrow band of the roof. Blocked drains make it worse: meltwater refreezes into ice that adds weight and does not drain. Garages, porches, additions, two-flats and commercial buildings with flat roofs deserve the most attention after a big storm. See our commercial roof maintenance page.
Warning signs of too much snow load
Inside: new cracks in drywall or plaster, interior doors that suddenly stick or will not latch, a ceiling that looks like it is sagging, popping or creaking sounds from the attic or roof, and new leaks. Outside: a visible dip in the roofline, bowed gutters, or water pooling where it never pooled before. On commercial buildings, sprinkler heads pushed below the ceiling line and cracked masonry near the roof are red flags. If you see these signs, keep people out from under the sag and call a professional before doing anything else.
Should you remove snow from your roof?
For most pitched homes, a roof rake used from the ground to clear the bottom 3 to 4 feet after a heavy snowfall is enough, and it helps with ice dams too. Do not climb onto a snow-covered roof. On flat roofs carrying heavy drifts or ice, removal should be done by people with fall protection who know where the drains and the membrane are; shovels and ice picks cut membranes, and a few inches of snow should be left in place to protect the surface. Never use salt or chemical ice melt on a roof. For the rest of the season, see our winter roof maintenance guide.
Older roofs and roofs with damage
A roof's capacity assumes the structure is intact. Rotted decking, sagging rafters, an old roof with multiple shingle layers, or framing cut for a skylight or a past remodel can all lower what a roof can safely carry. If your roof already sags in summer, or has two or three layers of shingles on it, treat heavy snow seriously. A roof health check in the spring will tell you what condition the deck and framing are in.
Need help with a snow-loaded or leaking roof?
If the roof is leaking, sagging, or ice has torn a gutter loose, call (708) 847-5418. For active damage see emergency roof repair and tarping. Leaders Roofing is family owned and operated, based in Mount Prospect since 1996, and works on residential and commercial roofs across Cook, DuPage and Lake Counties.
Frequently asked questions
How much does a foot of snow weigh on a roof?
It depends on the snow. FEMA's rule of thumb is that 10 to 12 inches of fresh, dry snow weighs about 5 pounds per square foot, while old packed snow reaches that weight at 3 to 5 inches. Wet, heavy snow can weigh several times more than powder at the same depth.
How much snow load is a Chicago-area roof designed for?
Building codes set a design snow load by region; the ground snow load commonly used for the Chicago area is around 25 pounds per square foot, adjusted for roof shape, slope and exposure. The exact value depends on the code edition your municipality has adopted.
When should I worry about snow on my flat roof?
After heavy wet snow, after snow on top of ice, when drifts build against parapets or higher walls, or when drains are frozen. Sticking doors, new ceiling cracks, creaking sounds or a visible sag mean you should keep people out of the area and call a professional.
Should I shovel my roof?
Not from on top of the roof. On a pitched roof, rake the lower few feet from the ground. Flat roofs with heavy loads should be cleared by people with fall protection who will not damage the membrane, leaving a few inches of snow in place.